Contents
If your chair is starting to sink, don’t despair! There are several ways you can fix a sinking chair, depending on the cause.
Checkout this video:
Introduction
A sinking chair is an annoying problem that can be caused by a variety of issues, such as a loose screw or a broken spring. Whatever the cause, it’s important to fix a sinking chair as soon as possible so that it doesn’t become a bigger problem. In most cases, you can fix a sinking chair with a few simple tools and a little bit of time.
What Causes a Sinking Chair?
The most common cause of a sinking chair is simply wear and tear. Over time, the materials in your chair will gradually break down, causing it to sink. This is especially true for chairs that see a lot of use, such as chairs in your living room or office.
Another common cause of a sinking chair is improper installation. If your chair was not installed correctly, or if it was not installed on a level surface, it is more likely to sink over time.
How to Fix a Sinking Chair
Sinking chairs are not only uncomfortable, but they can also be dangerous. If you have a sinking chair, there are a few things you can do to fix it. First, try to find the source of the problem. If the problem is with the legs, you can try to tighten the screws or replace the legs. If the problem is with the seat, you can try to add some stuffing to the seat or replace the seat.
Fill the Gap with Wood Filler
Start by cleaning out the area around the seat of the chair with a putty knife. Be sure to remove any loose paint or wood chunks. Next, fill the area with wood filler, using a putty knife to smooth it out. Allow the filler to dry for several hours before proceeding.
Reinforce the Chair with Dowels
If your chair is starting to sag in the middle, you can fix it by reinforcing the seat with dowels. You will need to remove the seat cushion and fabric first. Then, use a drill to make two pilot holes in each side of the seat. Next, insert dowels into the pilot holes and glue them in place. Finally, reupholster the seat and reattach it to the chair frame.
Replace the Damaged Joint
If your chair is starting to sink, it’s probably because one of the joints has come undone. To fix this, you’ll need to remove the old joint and replace it with a new one.
First, remove the seat cushion and any other removable parts from the chair. Then, use a screwdriver to loosen the screws that hold the chair frame together. Once the screws are loose, you should be able to separate the frame into two pieces.
Next, locate the damaged joint and remove it from the frame. To do this, you’ll need to remove the old nails or screws that are holding it in place. Once the joint is removed, you can measure it and cut a new one from a piece of wood that is the same size.
Finally, reattach the new joint to the frame using nails or screws. Then, reattach the seat cushion and any other parts that you removed earlier. Once everything is back in place, your chair should be as good as new!
Conclusion
There are a few things you can do to fix a sinking chair, depending on the problem. Loose legs can be tightened with screws or bolts. A broken or worn-out foot can be replaced with a new one. If the problem is more serious, such as a broken frame or leg, you may need to replace the entire chair.
